Skip navigation

Tag Archives: Joint Compound

Inside angles over ninety degrees can be difficult
to keep strait. This is generally due to uneven
framing. Just tape it like you normally would.
Once that mud dries, apply another thick coat
with a rounded rubber knife. Now you can run
mesh tape down the center and apply another
layer of joint compound. Feather the edges and
smooth out your mud. Allow this to dry
completely before moving on.

Copyright 2010, by Glenn Raymond.

     This is a matter of personal opinion based
on my 50 years of hands on experience.  That
old nemesis of mine, known as spackling may
have some type of legitimate uses, but not
necessarily in drywall repairs.

     The best way to patch small holes in your
drywall is with basic drywall compound (mud).
This magic compound can be purchased at most
major home repair suppliers and lumberyards.
Remeber, when it is pre-mixed, it still needs to
have a little water added and then mixed again
to remove all the lumps.  Mud shrinks as it dries,
so you may need to apply 2 or 3 layers, alowing
it to dry between each coat.

     There are also fast setting powdered products
you mix with water.  These work very well, but
set up quickly.  You will want to wash your tools
and hands right away.  Once it sets up, it is a bit
tricky to remove.

     Spackling simply does not give professional
results, and you don’t want to devalue your
home.  Working with mud will be far more
rewarding in the end.